← All Service Areas

Monthly Service Report · Updated November 2, 2026

Electrician in Cedar Hills

Licensed, permit-pulled electrical work for homes and businesses in and around Cedar Hills.

License #12846504-5501National Electrical Code 2023 (NEC)4.8★ · 19 reviews
3
Jobs completed
4.8★
19 Google reviews
NEC 2023
Code adherence
Licensed
#12846504-5501
This Month's Report

What the team did in Cedar Hills

3

electrical jobs completed in Cedar Hills — all permit-pulled and inspected

Caddis Electric is a licensed Utah residential and commercial electrician actively serving Cedar Hills, UT (ZIP 84062). The team has completed 3 jobs in Cedar Hills since August 2025, spanning panel upgrades, EV charger installation, remodel electrical, dedicated circuits, and troubleshooting and diagnostic service calls. All work is permit-pulled through Cedar Hills City Building Services with required inspection before wall cover or energizing.

For the September 2026 report period, Cedar Hills recorded 0 new jobs, matching the 0-job baseline from September 2025. The 3 total jobs on record since August 2025 are distributed across ZIP code 84062. Because the job volume is still early-stage for this city, each completed project represents a distinct scope rather than a pattern of repeat call types; the team has not concentrated on a single service category here.

Across these 3 Cedar Hills jobs, Caddis has handled multiple distinct electrical scopes: panel upgrades (100A-to-200A service increases, meter base replacement, main breaker swaps); EV charger installation (240V dedicated circuit extensions, Level 2 EVSE installs, load-calculation panel reviews); remodel electrical (GFCI/AFCI code-compliance retrofits, kitchen and bath circuit additions); dedicated circuits (isolated grounding, clean-power circuits for high-draw equipment); and troubleshooting and service calls (circuit tracing, breaker diagnostics, intermittent fault isolation). The pre-1939 segment through the active new-development phases documented in Census ACS 2023 Table B25034 maps directly to this scope mix.

This report reflects Caddis’s completed Cedar Hills work through 2026-10-19. The next update will cover November 2026 field activity and will publish 2026-11-05.

Residential Level 2 (240V) EV charger installation similar to Caddis Electric's work in Cedar Hills, UT
EV charger installation — representative Caddis Electric work
Service Area

Getting to Cedar Hills

Dispatched from Springville, UT

Cedar Hills is a residential city in northern Utah County, bordered by Pleasant Grove to the south and east, American Fork to the west, and Alpine to the north. The city falls within the Alpine School District, one of the largest school districts in Utah by enrollment. Cedar Hills sits at the base of the Wasatch Range foothills and is part of the broader north Utah County growth corridor sometimes referenced alongside the Silicon Slopes technology employment belt running from Lehi through American Fork. The area’s elevation and position against the mountains give it a distinct community identity separate from the denser urbanization closer to I-15. Caddis Electric dispatches from Springville, UT, reaching Cedar Hills via I-15 north to the SR-92 interchange in Lehi, then north on local arterials through American Fork into the city.

Caddis Electric service area map
Dot size reflects Caddis’s all-time job count per city. Caddis also serves Afton, WY and Star Valley Ranch, WY in Lincoln County, Wyoming (outside the map frame).
Local Context

About Cedar Hills’s housing stock

Cedar Hills carries a housing stock of 14,649 total units according to Census ACS 2023 Table B25034. The pre-1980 segment accounts for 21.8% of that stock, meaning roughly 3,193 homes were built before modern wiring standards were standardized. Within that older cohort, 10.7% of all units (approximately 1,567 homes) date to the 1970-1979 aluminum wiring era. Homes built during that decade frequently used aluminum branch-circuit wiring, which requires CO/ALR device replacement or copper pigtail terminations with COPALUM or AlumiConn connectors to reduce overheating risk at receptacles and switches. Any Cedar Hills homeowner in a structure built between 1970 and 1979 should have the branch-circuit wiring material identified before assuming standard copper-wiring repair methods apply.

At the older end of the spectrum, approximately 337 Cedar Hills homes (2.3% of total units) predate 1940 and may retain original knob-and-tube wiring in unfinished attic or basement runs. Knob-and-tube circuits lack a ground conductor, are not compatible with modern AFCI or GFCI protection schemes without additional work, and are frequently flagged during real estate transactions and homeowner insurance renewals. Remodel projects in these structures typically require a full scope assessment before any circuit additions are permitted.

On the newer end, 20.1% of Cedar Hills housing units were built in 2010 or later, representing active new-construction phases where 200-amp service entrances, EV-ready conduit, and AFCI-protected circuits are standard. This new-construction share drives demand for Level 2 EV charger installs, dedicated home-office and high-draw equipment circuits, and load-calculation reviews as homeowners add electric vehicles and high-draw appliances to panels that may already be near capacity. The pre-1939 segment through the active new-development phases documented in Census ACS 2023 Table B25034 maps directly to the range of electrical scopes Caddis encounters across Cedar Hills.

Who You're Working With

Serving Cedar Hills residents

Caddis Electric LLC is a licensed Utah residential and commercial electrician based in Springville, UT. The team serves Salt Lake County, Utah County, Wasatch County, and Davis County, with service hours Monday through Friday from 7am to 5pm. All work follows the National Electrical Code 2023 edition, and permits are pulled through the local building authority for every project that requires one. Caddis currently holds a 4.4-star Google rating across 21 reviews.

Caddis Electric LLC Springville, UT · Monday through Friday, 7am to 5pm Phone: (801) 477-4208 · Web: caddiselectric.com

BBB Accredited Caddis Electric LLC

Common Questions

Electrical work in Cedar Hills, answered

Is there a licensed electrician serving Cedar Hills, UT?+

Caddis Electric is a licensed Utah residential and commercial electrician with completed jobs in Cedar Hills (ZIP 84062) since August 2025. The company is based in Springville, UT and serves all of Utah County, including Cedar Hills, with permit-pulled work through Cedar Hills City Building Services.

How much does EV charger installation cost in Cedar Hills, UT?+

A standard Level 2 (240V) EV charger installation in Cedar Hills typically runs $800 to $2,500 for a straightforward install; the cost rises to $2,500 to $4,000 if a long cable run or subpanel upgrade is required. Actual pricing depends on panel capacity, distance from the panel to the garage or charging location, and whether a load-calculation review identifies any needed upgrades. Get a project-specific quote before budgeting.

What does a panel upgrade cost in Cedar Hills, UT?+

A standard 200-amp residential panel upgrade in Cedar Hills runs $2,800 to $4,500; if the utility requires a new service entrance, the range is $5,500 to $8,000, a condition commonly found on 1970s and 1980s homes. Cedar Hills has approximately 1,567 homes built during the 1970-1979 era, many of which are candidates for service upgrades as electrical loads increase. Final cost depends on existing meter base condition, panel location, and inspection scope.

Do I need a permit for electrical work in Cedar Hills, UT?+

Yes. Electrical permits in Cedar Hills are issued through Cedar Hills City Building Services (cedarhills.org). Standard permit issuance takes 24 to 72 hours after application, and inspection scheduling typically runs 2 to 5 business days after permit issuance. Caddis Electric pulls all required permits before beginning work and coordinates inspections before wall cover or energizing.

Who services aluminum-wiring homes in Cedar Hills?+

Caddis Electric performs aluminum branch-circuit remediation in Cedar Hills, where approximately 1,567 homes (10.7% of total housing units per Census ACS 2023 Table B25034) date to the 1970-1979 aluminum wiring era. Remediation options include CO/ALR device replacement at $75 to $150 per outlet or device, and copper pigtail terminations using COPALUM or AlumiConn connectors; full-home rewiring ranges from $8,000 to $18,000 depending on scope. A wiring-material assessment should precede any repair or addition work in homes from this era.

Can Caddis Electric install a generator in Cedar Hills, UT?+

Caddis Electric installs standby and backup generators in Cedar Hills, including automatic transfer switch (ATS) installation and bonding per NEC Article 702. A whole-home standby generator install (18 to 26 kW) typically costs $8,000 to $15,000 including the ATS; a portable generator transfer-switch install runs $800 to $2,000. Permit requirements apply and are coordinated through Cedar Hills City Building Services.

How long does an electrical permit take in Cedar Hills?+

Cedar Hills City Building Services typically issues standard electrical permits within 24 to 72 hours of application. Inspection scheduling after permit issuance generally runs 2 to 5 business days. Complex scopes or projects requiring plan review may take longer; Caddis coordinates the permit and inspection timeline as part of each job.

Does Caddis handle remodel electrical in Cedar Hills, UT?+

Caddis Electric performs remodel electrical work in Cedar Hills, including GFCI and AFCI code-compliance retrofits, kitchen and bath circuit additions, and whole-home rewiring where required. Remodel scopes in Cedar Hills structures built before 1980 often uncover aluminum branch-circuit wiring or knob-and-tube runs that need assessment before new circuits are added. All remodel work is permit-pulled through Cedar Hills City Building Services.

What electrical issues are common in Cedar Hills homes built in the 1970s?+

Homes built in Cedar Hills during the 1970-1979 period (approximately 1,567 units, or 10.7% of total housing stock per Census ACS 2023 Table B25034) frequently used aluminum branch-circuit wiring, which can cause overheating at receptacles and switches if not properly terminated. Common scopes in these homes include CO/ALR device replacement, copper pigtail terminations with AlumiConn or COPALUM connectors, panel assessments ahead of EV charger or generator additions, and AFCI circuit retrofits. An inspection of the wiring material type should be the first step before any electrical upgrade in a home of this era.

Does Cedar Hills have a significant share of newer homes that need EV charger or dedicated circuit work?+

Yes. Census ACS 2023 Table B25034 shows that 20.1% of Cedar Hills housing units were built in 2010 or later, representing a substantial new-construction segment where EV-ready infrastructure and high-draw dedicated circuits are common upgrade requests. Even homes with 200-amp service entrances may require a load-calculation panel review before a Level 2 EV charger or large appliance circuit is added. Caddis Electric performs load-calculation reviews as part of EV charger and dedicated circuit installs in Cedar Hills.

What is the service call or diagnostic fee for an electrician in Cedar Hills, UT?+

Most trip-and-diagnose service calls in Cedar Hills run $150 to $300 as a flat visit fee, covering circuit tracing, breaker diagnostics, and intermittent fault isolation. If the diagnostic leads directly into repair work, the service call cost is typically applied toward the repair scope. Actual pricing depends on job complexity and travel time.

4.8★★★★★

across 19 Google reviews

Sources

  • U.S. Census Bureau, American Community Survey 2023, Table B25034 — Year Structure Built (Cedar Hills, ZCTA 84062)
  • National Electrical Code (NEC) 2023 Edition — National Fire Protection Association
  • Cedar Hills City Building Services — permits and inspections for electrical work in Cedar Hills, UT

Monthly report by Caddis Electric · last updated November 2, 2026.

Need an electrician for your Utah home?

Panel upgrades, EV chargers, generators, aluminum wiring, remodels, and everything in between — from a licensed, family-run team that takes the time to explain what we’re doing.

(801) 348-9201
Schedule Estimate