Electrical Installations.
New work, not repairs. Panel upgrades, EV chargers, hot tub circuits, standby generators, ceiling fans, and whole-home remodels — permit-pulled, code-tight, done by a family-run Springville crew.
New work, not repairs on something that broke.
Installation work is anything we add to your home that wasn’t there before. A new EV charger because you just bought a Tesla. A dedicated 50A circuit because a hot tub is being delivered next week. A whole-home panel upgrade because you’re finishing the basement and the existing 100A service doesn’t have the headroom. A standby generator because you’ve been without power for 72 hours twice in the last two years and your home office can’t take a third. These are new installs, not fixes.
The common thread on every installation we do is a load calculation first. Before we talk about where the breaker goes or what gauge wire we’re running, we open your panel, inventory what’s already there, and figure out whether the service has capacity for what you want to add. On a modern 200A home with gas appliances, there’s usually plenty of headroom. On a 1970s 100A service with electric range, dryer, and summer AC load, there often isn’t — and we’ll tell you that honestly rather than pretend otherwise and leave you with a tripping panel.
Permits are part of installations. Panel upgrades, EV chargers, hot tubs, generators, new circuits in a remodel — every one of these gets a permit pulled with your city or county. American Fork, Lehi, Draper, Heber, Sandy, Pleasant Grove, Orem, Provo — we work in all of them, and the paperwork is part of doing it right. You get the permit sign-off at the end for your records, for your insurance carrier if they ask, and for the next time you sell.
We’re small enough that Tyler (or someone on his crew who’s been trained to the same standard) walks every install before quoting. There’s no commissioned closer trying to sell you a 400A panel you don’t need. If the honest answer is a 200A upgrade, that’s what we quote. If the honest answer is “you’re fine, just add this one dedicated circuit for the dryer,” that’s what we quote. We’d rather earn the next job than oversell this one.
Eight installations we do most.
These are the installations Utah homeowners call us for most often. Each has its own detail page with the full scope, FAQs, and the NEC articles that govern it.
Four signs it’s installation time.
You just bought a new electrical appliance
Electric vehicles, hot tubs, electric ranges, mini-splits, hot water heaters — anything with a nameplate load bigger than what you had before. A new circuit (and often a panel upgrade) has to go in before the appliance arrives.
You're remodeling or finishing a space
Kitchens, basements, primary suites, and detached ADUs all need modern circuit counts, GFCI and AFCI protection, dedicated circuits for appliances, and lighting layouts that work. Easier to do once than twice.
You lose power often and want backup
Mountainside neighborhoods in Alpine, Draper, Cottonwood Heights, and canyon-adjacent Heber see outages above the Utah average. A standby generator — sized honestly — is often the right answer.
You're planning for the next ten years
If an EV, a hot tub, a basement finish, or an electric heat pump is coming in the next few years, the right panel upgrade now saves you doing it piecemeal later. We think ahead so you don't have to.
“We size off the actual load calculation, not off a round number. A 400A panel isn’t the default answer — it’s the honest answer when the math actually calls for it.”
— Tyler Thorn, Owner
We install across Salt Lake County, Utah County, Wasatch County, Davis County from our Springville base. See all service areas →
Need an electrician for your Utah home?
Panel upgrades, EV chargers, generators, aluminum wiring, remodels, and everything in between — from a licensed, family-run team that takes the time to explain what we’re doing.
